Split System Installation in Carrum, VIC

Split system installation in Carrum

Carrum sits at the mouth of the Patterson River where it discharges into Port Phillip Bay, and the river mouth flood overlay covers a wide corridor along Nepean Highway and the streets immediately behind the foreshore. Melbourne Water publishes the 1-in-100-year flood extent for Carrum and about 40% of the residential grid west of Nepean Highway is inside the flood zone with property-title flood levels of 300 to 700mm. Practically that means Carrum installs are almost never on ground pads - the outdoor unit goes on a wall bracket at least 600mm above the ground, or on a purpose-built raised concrete plinth, or on the rear brick fence top. The 1960s beach cottages along McLeod Road, Old Post Office Lane and the foreshore streets have single-skin timber or fibro-clad walls and simple pipe routing - through-wall penetration is straightforward but always sealed with foam and colour-matched covers because rodent entry is a persistent bayside concern. Salt corrosion is severe on any Carrum outdoor unit within 500 metres of the beach and we spec coastal-treated Mitsubishi Electric or Fujitsu marine-grade condensers as a line item on beach-side quotes.

Direct bay exposure, Patterson River mouth flood zone, salt spray load year-round on beach-facing properties

Why Carrum homeowners choose Bellair

Carrum is 14 kilometres from our Botanic Ridge base via the Frankston Freeway and Nepean Highway - a 20-minute drive on a normal day, one of our quickest runs, and same-day quotes with 48-hour install turnarounds are usually achievable when the diary allows. The Patterson River mouth is a working boat harbour with the Carrum Yacht Club and boat ramps active year-round, and weekend traffic on Nepean Highway through Carrum picks up heavily on summer Saturdays - we schedule Carrum installs for weekday mornings or Saturday first-slot before 9am. The station is on the Frankston line and about 30% of Carrum customers are commuters on weekday-lockbox schedules. Kingston Council planning is straightforward and permits are rarely required for standard external installations. The new stacked apartment blocks near the station on Station Street were built post-2010 under strata title and those installs require owners corporation approval with the outdoor unit typically going on a rear balcony bracket or a communal roof plant deck. Winter southerlies drive rain horizontally into south-facing walls and we install a rear drip shield on any south or south-west facing outdoor unit as standard.

What's included in your Carrum install

Included in the Carrum quote: the split system in your chosen size and brand, all copper pipework and electrical cabling, coastal-spec heat exchanger option quoted separately for beach-adjacent addresses within 800 metres of the foreshore, stainless-steel wall brackets rated 600mm minimum above ground for flood-overlay properties (which is most of Carrum west of Nepean Highway), standard back-to-back install with a short pipe run, drain to the nearest legal point, controller pairing and commissioning on both cooling and heating cycles, cleanup and removal of packaging, full manufacturer warranty and our own 7-year workmanship guarantee. Not included: Kingston Council planning permits, owners corporation fees for apartment blocks near the station, engineering reports for raised plinth installations, electrical switchboard upgrades on pre-1980 buildings, penetrations through concrete slabs, and pipe runs longer than the standard 5-metre kit which are quoted per additional metre before we start work.

Get your Carrum quote in under a minute

We also install close to Carrum