Call 0416 105 912 Free Quotes · ARCtick AU 55218 · Same-Week Install
Get Free Quote →

Service area · Cranbourne VIC · South-East Melbourne growth corridor

Split System Installation in Cranbourne, VIC

Fixed-price installs from $1,690. ARCtick licensed, fully insured, 7-year workmanship warranty. Same-week appointments across Cranbourne and surrounding suburbs.

Split system installation in Cranbourne

Cranbourne's older than the estates that surround it — the stretch around High Street and the racecourse has weatherboard and brick homes going back to the fifties and sixties, well before the growth corridor swallowed everything east of it. That mix is what makes the work here varied. In an older brick home we're often dealing with cavity walls, eaves you don't drill blind into, and switchboards that were never built for a reverse-cycle load. So the first thing we check on a lot of Cranbourne jobs is whether the board can take it before we talk about where the head goes. Placement-wise the older floorplans are chopped into smaller rooms rather than open-plan, so a single big head in a knocked-through living area doesn't always suit — sometimes two smaller heads zoned properly beats one oversized one. Pipework needs planning too; on a double-brick home you can't just punch a hole wherever, so we route to keep the runs short and the outdoor unit somewhere sensible. Newer pockets of Cranbourne closer to the shopping centre are standard brick-veneer and much simpler. We've done enough around here to know the street-by-street difference between the old township stock and the infill. Sizing matters because these homes bake in summer with west sun and little eave shade, so we spec for the real heat load, not a sticker figure.

❄ Inland south-east — hot summer afternoons, west sun and little eave shade on the older homes

Why Cranbourne homeowners choose Bellair

Cranbourne's about five kilometres up the road from us in Botanic Ridge, so it's a short run and we're across the local housing stock. Typical jobs here run the gamut — replacing tired units in the older township homes, switchboard upgrades to carry the new load, and straightforward single-head fits in the newer brick-veneer pockets. Matt holds ARCtick licence AU 55218 and has 28 years on the tools, so the gas and electrical side is done properly. Every job comes with the full manufacturer warranty and our 7-year workmanship warranty. We install Mitsubishi Electric, Fujitsu, Toshiba, Panasonic, Samsung, Haier and LG, and we'll match the unit to the room rather than talk you into something you don't need. Price is fixed before we start.

What's included in your Cranbourne install

On a Cranbourne install you get supply of the unit, fitting to AS/NZS 3000, tidy back-to-back or routed pipework, condensate drainage, electrical connection, removal and recycling of the old unit, commissioning and a clean-up. On the older township homes we allow extra time for switchboard checks and careful drilling through double brick, so the pipework stays neat and nothing gets punched through blind. It's all in the fixed price agreed up front — if a board upgrade is needed we tell you before you commit, not after.

Postcode: 3977 · Council: City of Casey · Region: South-East Melbourne growth corridor

Typical home styles: 1950s-60s weatherboard, older brick township homes, post-war brick, newer brick veneer infill

Local landmarks: Cranbourne Racecourse · Royal Botanic Gardens Cranbourne (Australian Garden) · Cranbourne Park Shopping Centre

Get your Cranbourne quote in under a minute

We also install close to Cranbourne

Real Installs · Real Reviews

Verified 5-Star Google Reviews

Every review below is a verified Google review with photos of the actual installation.

Split system installation by Bellair for Arelys BarrySplit system installation by Bellair for Arelys Barry
Arelys BarryArelys Barry
Local Guide · 3 weeks ago
★★★★★

Matt and his team are exceptional. I sent a message Saturday morning, I received a text message and a phone call, and a site visit by 11am. I am not use to such high customer service. Matt tried to have my install done asap as we had no heating. Install was also exceptional, as his pricing and quality of install and removal of old unit is beyond expectations. Was not an easy job but his quote was so honest and fair. I can hardly notice the outside cabling (first photo). He was also so polite, professional and caring. Thank you Matt and team. Will contact shortly for further split systems install. I will only contact your company in the future. Also, your system recommendation has been amazing. Many, many thanks for everything.

Melbourne

Split system installation by Bellair for Milon PangSplit system installation by Bellair for Milon Pang
Milon PangMilon Pang
Local Guide · 2 days ago
★★★★★

Communication with Matt was seamless and transparent. He came to inspect my place prior for a quick chat and to issue an estimated quote not long after. We eventually had a date fixed for two units to be installed. One required replacement of the previous old unit (included removal from property), and the second required a new hole to be drilled for installation. Matt and his team took roughly 3.5-4h. They were immaculate with their work! They left my place decently clean. I would have to say that this was the best customer service that I have had. Everything was discussed clearly, and my questions were addressed appropriately by Matt. I would highly recommended them if you are still considering! Thank you very much, Matt and your boys!

Melbourne

Split system installation by Bellair for Alexander MoloksherSplit system installation by Bellair for Alexander Moloksher
Alexander MoloksherAlexander Moloksher
4 weeks ago
★★★★★

We recently had Samsung multi-head, multi-room split reverse cycle air conditioners installed throughout our home by Bellair, and we could not be happier with the outcome. Matt and his team completed the installation to the highest workmanship standards, with exceptional attention to detail and immaculate quality throughout the entire project. The finished result looks incredibly neat, professional, and well thought out. What truly stood out was Matt’s professionalism and communication at every stage of the installation. He kept us informed throughout the process, demonstrated outstanding competence and technical expertise, and delivered a flawless end result. It is clear that Matt and his team genuinely take pride in their work and customer satisfaction. I would highly recommend Bellair to anyone looking for high-quality air conditioning installation services.

Melbourne

Split system installation by Bellair for Michelle BellSplit system installation by Bellair for Michelle Bell
Michelle BellMichelle Bell
Frankston · 4 weeks ago
★★★★★

Highly recommend Bellair! Matt and the team installed a ducted heating and cooling system at my clinic in Frankston and the whole experience was fantastic from start to finish. Professional, reliable, great communication, and the quality of work was excellent. Matt was an absolute pleasure to deal with and made the whole process so easy. Could not be happier with the result!

Frankston

Split system installation by Bellair for Onyeka Robinson
Onyeka RobinsonOnyeka Robinson
Melbourne · 6 days ago
★★★★★

Matt did an excellent job installing our new Mitsubishi Electric heating and cooling system. He was professional, punctual, and took the time to explain everything clearly. The installation was completed to a high standard, and the work area was left clean and tidy. We're very happy with the result and appreciate the added peace of mind from the 5-year Mitsubishi Electric manufacturer warranty and 7-year Bellair workmanship warranty. Highly recommend Matt and the Bellair team.

Melbourne

FAQ

Common Questions About Split Systems

Most of our fixed-price split system installs fall between $1,690 and $1,890, depending on the unit, the size of the room and how the pipework needs to run. You get the all-inclusive price up front before we start — no surprises.
As a rough guide, a small bedroom suits a 2.5kW unit, a typical living room 5–6kW, and a large open-plan space 7kW or more. We measure properly during the site visit and size honestly so the system isn't over- or under-powered.
A standard single-head split system is usually done in 3–4 hours. Multi-head systems and trickier pipe runs can take most of a day. We'll give you a realistic time frame with your quote.
We supply and install Australia's most trusted brands — Mitsubishi Electric, Fujitsu, Haier, Samsung, Toshiba, Panasonic and LG. Every unit comes with a full manufacturer warranty plus our own 7-year workmanship guarantee.
We cover 190+ suburbs across the Mornington Peninsula, Bayside, South-East Melbourne, the inner east and the CBD. Chances are we've already done a job in your street — check our service areas below.
We recommend a service once a year to keep it running efficiently. We clean filters, check gas levels and test performance so your system lasts longer and runs cheaper.