Call 0416 105 912 Free Quotes · ARCtick AU 55218 · Same-Week Install
Get Free Quote →

Service area · Cannons Creek VIC · Western Port

Split System Installation in Cannons Creek, VIC

Fixed-price installs from $1,690. ARCtick licensed, fully insured, 7-year workmanship warranty. Same-week appointments across Cannons Creek and surrounding suburbs.

Split system installation in Cannons Creek

Cannons Creek sits directly opposite French Island - the ferry from Stony Point runs across Western Port and the northern end of the island is visible from the Cannons Creek foreshore on a clear day. Unlike Blind Bight down the road, Cannons Creek isn't a canal estate - it's a small tidal hamlet built along the natural creek line and mangrove edge, and the mangroves here are part of the Western Port Ramsar wetland listing, which limits any foreshore modification. That matters for install work: we cannot route condensate to the foreshore or into the mangrove drain, so on properties fronting the water the drain has to go to a stormwater connection or a proper on-site infiltration pit set back from the reserve boundary. Cannons Creek shares our 3977 postcode with Botanic Ridge, Cranbourne, and the surrounding Casey suburbs - that postcode overlap makes it one of the fastest local runs we do, 15 minutes from our base. Housing is a mix of 1960s and 70s weatherboard fishing shacks that have been progressively renovated into permanent residences, plus a later wave of 1990s and 2000s brick homes on the higher-ground streets away from the water. The older shacks almost always need a switchboard rebuild before a modern reverse-cycle install - many still have the original two-circuit ceramic-fuse boards - and Cook & Company come out on the same day for those jobs so we can finish the install cleanly.

Western Port foreshore, sheltered tidal shoreline, salt near the water, low flat blocks

Why Cannons Creek homeowners choose Bellair

Cannons Creek is about twelve kilometres south-east of our Botanic Ridge base - and shares our own 3977 postcode, so it's a local job. The work here is practical single and multi-head fits in modest coastal homes, careful footing and drainage on the low, flat blocks, coastal placement near the water, and switchboard upgrades on the older homes. Matt holds ARCtick licence AU 55218 with 28 years in the trade, so the refrigerant work is by the book. Every install carries the full manufacturer warranty plus our 7-year workmanship warranty. We fit Mitsubishi Electric, Fujitsu, Panasonic, Toshiba, Samsung, Haier and LG, and we'll match the unit to the home and budget rather than push a brand. Fixed price agreed before we start.

What's included in your Cannons Creek install

A Cannons Creek install includes supply of your chosen unit, fitting to AS/NZS 3000, neat back-to-back or routed pipework, condensate drainage, electrical connection, old unit removal and recycling, commissioning and clean-up. On the low, flat foreshore blocks we get the footing and drainage right and site the outdoor unit off the Western Port salt. It's all in the fixed price agreed up front, with any switchboard upgrade flagged before you commit.

Postcode: 3977 · Council: City of Casey · Region: Western Port

Typical home styles: holiday shacks, permanent single-level homes, weatherboard cottages, renovated coastal homes

Local landmarks: Cannons Creek foreshore · Cannons Creek boat ramp · Western Port

Get your Cannons Creek quote in under a minute

We also install close to Cannons Creek

Real Installs · Real Reviews

Verified 5-Star Google Reviews

Every review below is a verified Google review with photos of the actual installation.

Split system installation by Bellair for Arelys BarrySplit system installation by Bellair for Arelys Barry
Arelys BarryArelys Barry
Local Guide · 3 weeks ago
★★★★★

Matt and his team are exceptional. I sent a message Saturday morning, I received a text message and a phone call, and a site visit by 11am. I am not use to such high customer service. Matt tried to have my install done asap as we had no heating. Install was also exceptional, as his pricing and quality of install and removal of old unit is beyond expectations. Was not an easy job but his quote was so honest and fair. I can hardly notice the outside cabling (first photo). He was also so polite, professional and caring. Thank you Matt and team. Will contact shortly for further split systems install. I will only contact your company in the future. Also, your system recommendation has been amazing. Many, many thanks for everything.

Melbourne

Split system installation by Bellair for Milon PangSplit system installation by Bellair for Milon Pang
Milon PangMilon Pang
Local Guide · 2 days ago
★★★★★

Communication with Matt was seamless and transparent. He came to inspect my place prior for a quick chat and to issue an estimated quote not long after. We eventually had a date fixed for two units to be installed. One required replacement of the previous old unit (included removal from property), and the second required a new hole to be drilled for installation. Matt and his team took roughly 3.5-4h. They were immaculate with their work! They left my place decently clean. I would have to say that this was the best customer service that I have had. Everything was discussed clearly, and my questions were addressed appropriately by Matt. I would highly recommended them if you are still considering! Thank you very much, Matt and your boys!

Melbourne

Split system installation by Bellair for Alexander MoloksherSplit system installation by Bellair for Alexander Moloksher
Alexander MoloksherAlexander Moloksher
4 weeks ago
★★★★★

We recently had Samsung multi-head, multi-room split reverse cycle air conditioners installed throughout our home by Bellair, and we could not be happier with the outcome. Matt and his team completed the installation to the highest workmanship standards, with exceptional attention to detail and immaculate quality throughout the entire project. The finished result looks incredibly neat, professional, and well thought out. What truly stood out was Matt’s professionalism and communication at every stage of the installation. He kept us informed throughout the process, demonstrated outstanding competence and technical expertise, and delivered a flawless end result. It is clear that Matt and his team genuinely take pride in their work and customer satisfaction. I would highly recommend Bellair to anyone looking for high-quality air conditioning installation services.

Melbourne

Split system installation by Bellair for Michelle BellSplit system installation by Bellair for Michelle Bell
Michelle BellMichelle Bell
Frankston · 4 weeks ago
★★★★★

Highly recommend Bellair! Matt and the team installed a ducted heating and cooling system at my clinic in Frankston and the whole experience was fantastic from start to finish. Professional, reliable, great communication, and the quality of work was excellent. Matt was an absolute pleasure to deal with and made the whole process so easy. Could not be happier with the result!

Frankston

Split system installation by Bellair for Onyeka Robinson
Onyeka RobinsonOnyeka Robinson
Melbourne · 6 days ago
★★★★★

Matt did an excellent job installing our new Mitsubishi Electric heating and cooling system. He was professional, punctual, and took the time to explain everything clearly. The installation was completed to a high standard, and the work area was left clean and tidy. We're very happy with the result and appreciate the added peace of mind from the 5-year Mitsubishi Electric manufacturer warranty and 7-year Bellair workmanship warranty. Highly recommend Matt and the Bellair team.

Melbourne

FAQ

Common Questions About Split Systems

Most of our fixed-price split system installs fall between $1,690 and $1,890, depending on the unit, the size of the room and how the pipework needs to run. You get the all-inclusive price up front before we start — no surprises.
As a rough guide, a small bedroom suits a 2.5kW unit, a typical living room 5–6kW, and a large open-plan space 7kW or more. We measure properly during the site visit and size honestly so the system isn't over- or under-powered.
A standard single-head split system is usually done in 3–4 hours. Multi-head systems and trickier pipe runs can take most of a day. We'll give you a realistic time frame with your quote.
We supply and install Australia's most trusted brands — Mitsubishi Electric, Fujitsu, Haier, Samsung, Toshiba, Panasonic and LG. Every unit comes with a full manufacturer warranty plus our own 7-year workmanship guarantee.
We cover 190+ suburbs across the Mornington Peninsula, Bayside, South-East Melbourne, the inner east and the CBD. Chances are we've already done a job in your street — check our service areas below.
We recommend a service once a year to keep it running efficiently. We clean filters, check gas levels and test performance so your system lasts longer and runs cheaper.